Control Panel - Ariston FTCF 97B Instruction Booklet

Control panel

GB
The ON/OFF button
turned off, it counts down 3, 2, 1, Off and the programme is then cancelled. Press and hold for more than 3 seconds
and the dryer reactivates.
The PROGRAMMES knob sets the programme: rotate it until the indicator is pointing to the programme you want to
select (see Start and Programmes).
The OPTION buttons select available options for your selected programme. The lights indicate that the option has been
selected.
The START/PAUSE button/light
and the progress lights will flash to confirm the action. When a programme is running, pressing this button in pauses
the programme and stops the dryer. The light is green when programme is running, flashing amber if the programme
has been paused or flashing green if on standby waiting to start a programme.
The Display Unit gives an indication of the drying or delay time together with icons that light to give warning information
and show the status of your programmes progress.
The three buttons below the display select 'Automatic' or 'Timed Dry' and if required a delayed start (see Start and
Programmes or The Display).
The Child Lock button/light
turns on. This prevents the programme settings from being changed. When the light is lit, the other buttons are disabled.
Hold the button to cancel and the light will go out.
The Empty Water icon
to update after replacing the empty water container, the dryer must be running for this to happen (see The Controls).
Note: If the water container fills the 'water container full 'icon
off and your clothes will not dry.
The Clean Filter icon
dryer is used (see Maintenance and Care).
The Clean Condenser icon
Maintenance and Care).
8
PROGRAMME
knob
ON/OFF
Button
: If the dryer is running and this button is pressed and held for more that 3 seconds the dryer is
starts a selected programme. When you press this button there will be one beep
: Press and hold this button after selecting your programme and any options, the light
: signals that the water container should be emptied. The display will take a few seconds
: gives a reminder before every programme, that it is essential to clean the filter every time the
: gives a reminder that it is essential to clean the condenser at regular intervals (see
Indicator Child
Button & Light
1
Display Unit &
Selection Buttons
Buttons & Lights
flashes, the display shows "H20", the heat is turned
HEAT LEVEL
Lock
Button & Lights
OPTION START/PAUSE
Button & Light