Checking The Gyro Sensivity In Flight - Carson CG-1 Instruction Manual

14. Checking the gyro sensivity in flight

GB
Warning!!!
Before you start the model on the airfield, allow the gyro CG-1 to
warm up to ambient temperature with a receiving system turned
on. Switch the received off after approx. 5 minutes and then back
on again.
Your gyro CG-1 system is now operational.
First hover your model on the spot. Then turn the control stick for
the tail function slightly and let it go suddenly so that it bounces
around the neutral position. If the tail catches itself without
swinging, the gyro sensitivity can be increased. If, however, the
tail swings out further, the sensitivity is set too high. The best
sensitivity is achieved if the tail is just about to swing.
Please note:
• The maximum adjustable gyro sensitivity depends on the
rotation speed of the main rotor.
• The higher the set main rotor speed, the lower the maximum
fl yable gyro sensitivity.
• At a gyro sensitivity of less than 70%, the servo lever (see
page 12, pos. 12) should be reduced or the control rods
installed further to the centre on the servo lever.
• At a gyro sensitivity of less than 100%, the servo lever (see
page 12, pos. 12) should be increased or the control rods
installed further to the outside on the servo lever.
20
CARSON Gyro 507027