Operating The Cg-1 Gyro - Carson CG-1 Instruction Manual

Warning!
GB
If the gyro is connected as described above, it works in dual
mode. The installation of the gyro sensitivity and the selection of
the operating typet (standard or heading lock) are provided via
the sender.
If the 1-pin normal input of the gyro (2) is not connected, the gyro
works in single mode. The gyro sensitivity is set on the settings
controller of the gyro (see page 9, Pos. 5) and the gyro works in
the heading lock operating mode only.

9. Operating the CG-1 Gyro

Before you launch the gyro for the first time, all tail mixed
programs programmed in the sender, such as revolution mix or
gyro hide mixer, must first be deactivated.
The gyro has no function switch. The power supply is provided via
the 3-pin plug connection which is connected to the receiver.
As soon as the receiving system is switched on, the gyro is in
operation.
The steering stick for the tail function and the associated trim
lever must be in central position, before you operate the reception
system and the gyro.
The tail rotor should then be aligned so that the helicopter has no
tendency to turn to the side (factory settings) in hovering flight.
14
CARSON Gyro 507027