Setting Gyro Sensitivity "Gain" (Single Mode); Setting The Effective Direction Of Your Cg-1 - Carson CG-1 Instruction Manual

12. Setting gyro sensitivity
GB
"GAIN" (single mode)
Gyro CG-1 sensitivity in single mode is set
on the gain controller of the gyro (5).
Use a suitable screwdriver. If the controller
is turned right to the left, the gyro sensiti-
vity is 0%. If the controller is turned right to
the right, the gyro sensitivity is 100%.
13. Setting the effective direction of your
CG-1
For the gyro to prevent the helicopter model from turning around
the vertical axis (rotor shaft), it must always produce a tail servo
control command which creates an opposing turn. Launch the
sender and then turn on the model.
If the tail is now pressed by hand to the left, when looking from the
top, the tail servo must perform a control movement which would
turn the tail back to the right. The turning movement of the servo
must go in the same direction as when the sender of the control
stick for the tail function is actuated to the left (drawing A).
If the tail is now pressed by hand to the left, when looking from the
top, the tail servo must perform a control movement which would
turn the tail back to the right. The turning movement of the servo
must go in the same direction as when the sender of the control
stick for the tail function is actuated to the right (drawing B).
18
CARSON Gyro 507027
5
6