Nikon Z 50 Reference Manual page 349

Network Settings
Select Create profile to create a new network profile (0 353,
357). If more than one profile already exists, you can press J to
select a profile from a list. To edit an existing profile, highlight it
and press 2. The following options will be displayed:
• General: The profile name and password. Select Profile name to
rename the profile (by default, the profile name is the same as
the network SSID). To require that a password be entered
before the profile can be changed select On for Password
protection (to change the password, highlight On and press
2).
• Wireless: Adjust settings for connection to a network via a router
(infrastructure mode) or for direct wireless connection to the
camera (access-point mode).
- Infrastructure mode: Enter the network SSID and password and
choose the type of authentication/encryption used on the
network (OPEN or WPA2-PSK-AES). The channel is selected
automatically.
- Access-point mode: Enter the SSID and choose a channel (select
Auto for automatic channel selection or Manual to choose
the channel manually) and authentication/encryption type
(OPEN or WPA2-PSK-AES) used for connection to the
camera. If WPA2-PSK-AES is selected for Authentication/
encryption, you can also set the camera password.
• TCP/IP: If Enable is selected for Obtain automatically, the IP
address and sub-net mask for infrastructure mode connections
will be acquired via a DHCP server or automatic IP addressing.
Select Disable manually to enter the IP address (Address) and
sub-net mask (Mask). Note that an IP address is required for
infrastructure mode connections.
Menu Guide > B The Setup Menu
321