Table 96 System Error Logs; Table 97 Packet Filter Logs; Table 98 Icmp Logs; Table 99 Cdr Logs - ZyXEL Communications ADSL/ADSL2/ADSL2+ Router 660R-6xC Series User Manual

Prestige 660R-6xC Series User's Guide

Table 96 System Error Logs

LOG MESSAGE
%s exceeds the max.
number of session per
host!
setNetBIOSFilter: calloc
error
readNetBIOSFilter: calloc
error
WAN connection is down.

Table 97 Packet Filter Logs

LOG MESSAGE
[ TCP | UDP | ICMP | IGMP |
Generic ] packet filter
matched (set: %d, rule: %d)

Table 98 ICMP Logs

LOG MESSAGE
Packet without a NAT table entry
blocked: ICMP
Router reply ICMP packet: ICMP

Table 99 CDR Logs

LOG MESSAGE
board %d line %d channel %d,
call %d, %s C01 Outgoing Call
dev=%x ch=%x %s
271
DESCRIPTION
This attempt to create a NAT session exceeds the maximum
number of NAT session table entries allowed to be created per
host.
The router failed to allocate memory for the NetBIOS filter settings.
The router failed to allocate memory for the NetBIOS filter settings.
A WAN connection is down. You cannot access the network
through this interface.
DESCRIPTION
Attempted access matched a configured filter rule (denoted by
its set and rule number) and was blocked or forwarded
according to the rule.
DESCRIPTION
The router blocked a packet that didn't have a
corresponding NAT table entry.
The router sent an ICMP reply packet to the sender.
DESCRIPTION
The router received the setup requirements for a call. "call" is
the reference (count) number of the call. "dev" is the device
type (3 is for dial-up, 6 is for PPPoE, 10 is for PPTP).
"channel" or "ch" is the call channel ID.For example,"board 0
line 0 channel 0, call 3, C01 Outgoing Call dev=6 ch=0
"Means the router has dialed to the PPPoE server 3 times.
Appendix G