Used Batteries; Storage; Wall Mounted Charger - Parkside PAPK 12 A2 Translation Of The Original Instructions

3. Insert the battery (1) in the char-
ging compartment of the battery
charger (3).
4. Pull the battery (1) out of the
battery charger (3).
5. Unplug the battery charger (3)
from the mains.
Overview of the LED indi-
cators on the charger (3):
inserted: Charger ready.
alleged charged.

Used batteries

• If a fully recharged battery lasts
for considerably shorter opera-
ting times, the battery is used up
and needs to be replaced. Only
use an original replacement
battery from the Parkside X 12
V Team series, which can be
purchased from the online shop
(see the "Spare parts" section).
• Always take heed of the appli-
cable safety instructions as well
as the environmental protection
regulations and information (see
"Cleaning and Maintenance").
Green LED (5) lights
up without battery
Green LED (5) lights
up: Battery such
Red LED (4) lights
up: Battery charging.

Storage

• Only store the batteries in the
partially-charged state. During
prolonged storage, 2 to 3 LEDs
should be illuminated.
The battery's (1) charge level is
indicated by the charge state
indicator.
• Remove the battery before storing
the unit for longer periods of time.
• During a longer storage period,
check the state of charge of the
battery and recharge if neces-
sary roughly every 3 months.
• The ideal storage temperature
for the battery is between 0 °C
and 45 °C. Avoid extreme cold
or heat during storage to ensure
the battery output is not adver-
sely affected.

Wall mounted charger

(optional)
You can also mount the charger (3)
on the wall.
• Using dowels, place two screws
54 mm apart at the desired po-
sition of a wall.
• The screw head can have a dia-
meter of 7 - 9 mm
• Leave the screw heads protru-
ding at a distance of approx.
10 mm from the wall.
• With the openings of the wall
bracket, you can attach the
charger (3) to the two screws
and pull the charger down until
it stops.
GB IE
23