Husqvarna K 970 III, K 970 III Rescue, K 970 SmartGuard Operator's Manual page 26

Maintenance schedule
The maintenance schedule shows the necessary
maintenance of the product. The intervals are calculated
on daily use of the product.
Clean
Function inspection
Replace
Safety devices on the product on page 10 .
* Refer to
Cutting blades on page 12 .
** Refer to
To clean externally
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
To clean the air intake
Note: A dirty or blocked air intake makes the product too
hot. This can cause damage to the piston and cylinder.
• Clean the air intake if it is necessary.
• Remove blockage, dirt and dust with a brush.
To examine the spark plug
CAUTION: Always use the recommended
spark plug type. Use of the incorrect spark
plug can cause damage to the piston and
cylinder. For recommended spark plug refer
Technical data on page 33 .
to
Examine the spark plug if the product is low on power,
does not start easily or if it operates unsatisfactorily at
idle speed.
26
Daily
External cleaning
Cold air intake
General inspection
Fuel leaks
Water delivery system
Throttle lockout*
Stop switch*
Blade guard and SmartGuard*
Cutting blade**
Weekly
Vibration damping system*
Muffler*
Drive belt
Carburetor
Starter housing
1. Loosen the 4 screws and remove the air filter cover.
2. Make sure that the spark plug cap and ignition cable
are not damaged.
Monthly Yearly
Spark plug
Fuel tank
Fuel system
Air filter
Clutch
Fuel filter
1429 - 001 - 16.04.2020