At+Cwstartsmart-Starts Smartconfig; At+Cwstopsmart-Stops Smartconfig - Espressif ESP32 At Instruction Set

!
4.2.15. AT+CWSTARTSMART—Starts SmartConfig
Commands
Response
Parameters
Notes
Example
4.2.16. AT+CWSTOPSMART—Stops SmartConfig
Execute Command
Response
Parameters
Espressif
Execute Command:
AT+CWSTARTSMART
Function: to start SmartConfig. (The type of
SmartConfig is ESP-TOUCH + AirKiss.
OK
<type>:
‣ 1: ESP-TOUCH
‣ 2: AirKiss
‣ 3: ESP-TOUCH+AirKiss
For details on SmartConfig please see
•
• SmartConfig is only available in the ESP32 Station mode.
The message Smart get Wi-Fi info means that SmartConfig has successfully acquired the AP
•
information. ESP32 will try to connect to the target AP.
• Message Smartconfig connected Wi-Fi is printed if the connection is successful. Use command AT
+CWSTOPSMART to stop SmartConfig before running other commands. Please make sure that you do
not execute other commands during SmartConfig.
AT+CWMODE=1
AT+CWSTARTSMART
AT+CWSTOPSMART
OK
-
Irrespective of whether SmartConfig succeeds or not, before executing any other AT
Note
commands, please always call AT+CWSTOPSMART to release the internal memory taken up by
SmartConfig.
Example
AT+CWSTOPSMART
Set Command:
AT+CWSTARTSMART=<type>
Function: to start SmartConfig of a designated
type.
ESP-TOUCH User
20 53 ! /!
4. Wi-Fi AT Commands
Guide.
2017.02