Table 13 Wireless Settings: Bridge - ZyXEL Communications ZyXEL ZyAIR G-570S User Manual

Table 13 Wireless Settings: Bridge

LABEL
Operation Mode
SSID
Hide SSID
Channel
Wireless Mode
Local MAC
Address
Remote MAC
Address 1~4
Advanced Settings
Beacon Interval
Intra-BSS Traffic
DTIM Interval
Radio Enable
Chapter 6 Wireless Screens
DESCRIPTION
Select the operating mode from the drop-down list. The options are Access Point,
Wireless Client, Bridge and AP+Repeater.
Note: If you are configuring the device from a computer connected
to the wireless LAN and you change the device to use bridge
mode, you will lose your wireless connection when you click
Apply to save your settings. You must then connect to the
device through the wired network.
The device does not use the SSID with bridge mode. You do not need to configure
it.
The device does not use the SSID with bridge mode. You do not need to configure
this field.
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box.
Refer to the chapter on wizard setup for more information about channels.
Select 802.11b only to allow only IEEE 802.11b compliant WLAN devices to
associate with the device.
Select 802.11g only to allow only IEEE 802.11g compliant WLAN devices to
associate with the device.
Select Auto (11g/11b) to allow either IEEE 802.11b or IEEE 802.11g compliant
WLAN devices to associate with the device. The transmission rate of your device
might be reduced.
This is the MAC address of the device.
Type the MAC address of the peer device in a valid MAC address format, that is,
six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Set the number of milliseconds that should pass between the sending out of
beacons.
Intra-BSS traffic is traffic between wireless stations in the same BSS.
Enable Intra-BSS traffic to allow wireless stations connected to the device to
communicate with each other.
Disable Intra-BSS traffic to only allow wireless stations to communicate with the
wired network, not with each other.
Set the interval for wireless clients in sleep mode to wake up and check for
multicast or broadcast traffic.
The AP includes a Delivery Traffic Indication Message (DTIM) in the beacon to
notify wireless clients in sleep mode that there is a multicast or broadcast packet
awaiting delivery. The interval is a multiple of the beacon interval. For example, if
the beacon interval is 100 milliseconds and the DTIM interval is 2, the AP includes
a DTIM with every second beacon (or every 200 milliseconds).
Turn on the wireless adapter to allow wireless communications between the device
and other IEEE 802.11b and IEEE 802.11g compliant wireless devices. Turn off
the wireless adapter to stop wireless communications between the device and
other IEEE 802.11b and IEEE 802.11g compliant wireless devices.
ZyXEL G-570S User's Guide
69