Applying An Ip Policy; Ethernet Ip Policies; Figure 15-6 Menu 3.2 - Tcp/Ip And Dhcp Ethernet Setup - ZyXEL Communications ZyXEL ExpWave 240B User Manual

ExpWave 240B Secure Outdoor Ethernet Radio Link
FIELD
Len Comp
Source
addr start / end
port start / end
Destination
addr start / end
port start / end
Action
Gateway addr
Type of Service
Precedence
Log
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC] to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

15.5 Applying an IP Policy

This section shows you where to apply the IP policies after you design them.

15.5.1 Ethernet IP Policies

From Menu 3 – Ethernet Setup, type 2 to go to Menu 3.2 – TCP/IP and DHCP Ethernet Setup.
You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, for example, 2, 4, 7,
9.
Press Space Bar to Toggle.
15-4
Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal,
Less, Greater, Less or Equal or Greater or Equal.
Source IP address range from start to end.
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Specifies whether action should be taken on criteria Matched or Not Matched.
Defines the outgoing gateway address. The gateway must be on the same
subnet as the EXPWAVE if it is on the LAN, otherwise, the gateway must be
the IP address of a remote node. The default gateway is specified as 0.0.0.0.
Set the new TOS value of the outgoing packet. Prioritize incoming network
traffic by choosing No Change, Normal, Min Delay, Max Thruput, Max
Reliable or Min Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or No
Change.
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
system log when a policy is executed.
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
DHCP= Server
Configuration:
Client IP Pool Starting Address= 192.168.1.33
Size of Client IP Pool= 32
Primary DNS Server= 0.0.0.0
Secondary DNS Server= 0.0.0.0
DHCP Server Address= N/A
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-1
IP Policies= 2,4,7, 9
Press ENTER to Confirm or ESC to Cancel:
Figure 15-6 Menu 3.2 — TCP/IP and DHCP Ethernet Setup
DESCRIPTION
Type IP Policy
sets,
separated by
commas.
IP Policy Routing