Preparation; Connecting The Ac Power Cord - BOXLIGHT SP-10t User Manual

Preparation

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-120 V or 200-240
V AC. This projector automatically selects the correct input
voltage. It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce risk of electrical
shock, do not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of the type of power supply being in use.
Connect a projector with a peripheral equipment before turning a
projector on. (Refer to page 15 –16 for connection.)
CAUTION
For safety, unplug the AC Power Cord when an appliance is not used.
When this projector is connected to the outlet with the AC Power Cord,
an appliance is in Stand-by Mode and consumes a little electric power.
Note:
The AC Power Cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below. The proper AC power cord must be used.
If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.
Projector side
To the POWER CORD
CONNECTOR on the
projector.
12
AC Outlet side
For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
Connect AC Power Cord (supplied) to the
projector. The AC outlet must be near this
equipment and must be easily accessible.
For Continental Europe
To the AC Outlet.
(200 - 240 V AC)