Replacing The Lamp - Zanussi ZQA14030DA User Manual

Problem
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
There is too much condensed
water on the rear wall of the re-
frigerator.
There is frost on the rear wall
of the refrigerator.
Door does not open easily.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Possible cause
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrapped.
The ambient temperature is
high and the appliance is set to
the lowest temperature
The appliance is fully loaded
and is set to the lowest tem-
perature.
You attempted to re-open the
door immediately after closing.

REPLACING THE LAMP

Solution
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
Open the door only when nec-
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Set the temperature regulator
to a higher temperature to al-
low automatic defrosting.
Set the temperature regulator
to a higher temperature to al-
low automatic defrosting.
Wait a few seconds between
closing and re-opening of the
door.
The appliance is equipped with a long-
life LED interior light.
9