Replacing The Lamp; Closing The Door - Zanussi ZANZEAN11EW0 User Manual

Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.

REPLACING THE LAMP

The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service Centre.
Possible cause
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The Super Freeze function is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The Super Freeze function is
switched on.

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation" chapter.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Attach the melting water outlet
to the evaporative tray.
Switch off the Super Freeze
function manually, or wait until
the function deactivates auto-
matically to set the tempera-
ture. Refer to "Super Freeze
function" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "Super Freeze func-
tion" section.
71