Troubleshooting - Zanussi ZQA14030DA User Manual

CAUTION! If you want to keep the
appliance switched on, ask somebody
to check it once in a while to prevent
the food inside from spoiling in case of
a power failure.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
The lamp does not work.
The compressor operates con-
tinually.
Water flows on the rear plate
of the refrigerator.
Water flows into the refrigera-
tor.
8
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrectly.
Many food products to be fro-
zen were put in at the same
time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
During the automatic defrost-
ing process, frost melts on the
rear plate.
The water outlet is clogged.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
This is correct.
Clean the water outlet.