Replacing The Lamp; Closing The Door - Zanussi ZRDN18FS2 User Manual

Problem
DEMO appears on the display.
A or or
shown instead of numbers on
the temperature display.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.

REPLACING THE LAMP

The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service Centre.
The door has been opened of-
ten.
The FastCool function is
switched on.
There is no cold air circulation
in the appliance.
The appliance is in the demon-
stration mode.
Temperature sensor problem.
symbol is
Possible cause

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Open the door only if necessa-
ry.
Refer to "FastCool function"
section.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and tips" chap-
ter.
To exit the demonstration
mode, press and hold the OK
button for approximately 10
seconds until you hear a long
sound and the display turns off
for a short time.
Contact the nearest Author-
ized Service Centre. The cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible.
15