SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. •...
• Do not put electrical appliances (e.g. ice cream • Before maintenance, deactivate the appliance makers) in the appliance unless they are stated and disconnect the mains plug from the mains applicable by the manufacturer. socket. • Be careful not to cause damage to the •...
CAUTION! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.
• do not store warm food or evaporating liquids in • Cooked foods, cold dishes: cover and place on the refrigerator any shelf. • do cover or wrap the food, particularly if it has a • Fruit and vegetables: clean thoroughly and strong flavour place in a special drawer.
DEFROSTING OF THE REFRIGERATOR PERIODS OF NON-OPERATION Frost is automatically eliminated from the When the appliance is not in use for long periods, evaporator of the refrigerator compartment every take the following precautions: time the motor compressor stops, during normal 1.
Page 8
Problem Possible cause Solution The compressor operates con- Temperature is set incorrectly. Refer to "Operation" chapter. tinually. Many food products to be fro- Wait a few hours and then zen were put in at the same check the temperature again. time.
Problem Possible cause Solution Stored food was not wrapped. Wrap food in suitable packag- ing before storing it in the ap- pliance. Door does not open easily. You attempted to re-open the Wait a few seconds between door immediately after closing. closing and re-opening of the door.
Page 10
To ensure best performance, install the appliance well away from sources of heat such as radiators, boilers, direct sunlight etc. Make sure that air can circulate freely around the back of the cabinet. POSITIONING Install the appliance in a dry, well ventilated indoors where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance.
TECHNICAL DATA TECHNICAL DATA Height Width Depth Voltage Volts 230 - 240 Frequency The technical information is situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENTAL CONCERNS with the symbol with the household waste.
Need help?
Do you have a question about the ZQA14031DV and is the answer not in the manual?
Questions and answers