Table of Contents
Advertisement
The SimulScope is powered either from the AC line by use of the wall transformer or by the
internal rechargeable battery.
The SimulScope battery is rechargeable and will operate approximately 2.5 hours continuously
when fully charged. The green power light on the SimulScope will turn orange to indicate a low
battery condition. The SimulScope will operate for about 30 minutes after the low battery is indicated.
A fully discharged battery will recharge overnight (13-16 hours) when connected to the wall
transformer. See 2.1 below.
The Heartman Infrared Headphones are also battery-operated (standard or alkaline 9V.) and will operate
continuously for 150 or more hours at which time the battery should be replaced. A low battery indicator
flashes when it is time to change the headphone battery.
2.0 Set up
2.1 Charging the battery or Using the Wall Transformer
The SimulScope is charged by using the supplied wall transformer. To use, insert the wall transformer
into a 120V AC (or 220-240V. if outside US) wall socket and the insert the cable into the DC IN port on
the rear panel of the SimulScope. The SimulScope also can be operated in this manner with a depleted
battery or without a battery. The battery charger operates on either 110V or 220V.
Figure 6 Power Supply (110V and 220V)
7
Advertisement
Table of Contents
