Delete All; Loop Checkbox; Saving Programs; Exiting Programming Mode - Thames & Kosmos Robotics Smart Machines Experiment Manual

WRITING PROGRAMS
O

DELETE ALL

To clear an entire program and set it back to the
default blank program mode, press the trash can
button (O) in the menu bar. This also resets the
range markers to the default settings.
P

LOOP CHECKBOX

When the loop checkbox (P) is checked, the program
segment will run in a continuous loop, over and over
again, when the program segment is active.
When the loop checkbox is unchecked, the program
Q
segment will run just once when the program
segment is triggered.
SWITCHING BETWEEN PROGRAMS
If you want to move to a different program, click the
storage box button (Q) and select which program
you want to open.
S R

SAVING PROGRAMS

When you want to save a program you have written,
press the disk button (R). The program script will
immediately be saved inside the program (1-6) you
are currently in. A confirmation screen will appear.
REVERT TO SAVED
To revert to the last saved version of the program
and erase all unsaved changes, press the revert to
T
saved button (S).

EXITING PROGRAMMING MODE

When you want to leave the programming screen,
press the door button (T). A window will pop up
asking if you are sure you want to leave the
programming screen. Press the green check mark
button to go back to the main remote screen.
14