Inel ST-01RL Instructions For Installation And Use

ST-01RL roller blind control unit
Instructions for installation and use
Safety guidelines
Basic guidelines
The ST-01RL controller can be safely installed and used provided all of the following instructions of installation and use as well as
obligatory health and safety regulations are adhered to.
The installation and repairing of electrical equipment should be carried out only by persons with appropriate legal qualifications.
Reconstructing or making changes to the ST-01RL controller is forbidden. During the guarantee period repairs only the manufacturer
may carry out repairs. Even after the guarantee period has expired only original parts and accessories may be used.
The guarantee is only valid when the ST-01RL controller has been used in accordance with the manufacturer's instructions. The
boundary values given in the technical specifications must NOT be exceeded under any circumstances.
Supplementary safety regulations
When installing, using or carrying out maintenance work all binding health and safety regulations should be followed. Particular
attention should be paid to the following:
1. European Standards
2. Fire regulations
3. Accident avoidance regulations
GENERAL COMMENTS REGARDING HAZARDS AND SAFETY PRECAUTIONS
.
The following comments serve as general guidelines to the application of INEL drivers with other devices. These
guidelines must always be adhered to when installing and operating these devices
Warning – this signal warns of possible damage to the control system or other equipment if appropriate safety measures
are not taken.
 Before installing the control system and setting the end switches check all bolt connections are properly
fastened.
Danger – this signal indicates danger to the user's life and health if appropriate safety measures are not taken.
 Follow all health and safety regulations relevant to the equipment (e.g. gates, roller blinds) used.
 When changing fuses the equipment must be first disconnected from the mains, the fuses changed and only then may the
equipment be reconnected to the mains.
 The ST-01RL controller should be installed in accordance with appropriate safety regulations and with appropriate safety
devices.
 INEL equipment connected to the mains beyond a building's safety fuse system needs to be installed with its own safe
disconnecting devices (e.g. safety fuses and safety switches) in such a way so as to ensure that all the units may be easily and
safely cut off from the mains.
 Electric wiring and cables should be regularly checked to ensure the insulation is intact and there are no breaks in the wire.
 If any damage to the wiring is found, the unit should be immediately disconnected from the mains and the damaged wiring
replaced.
 Before connecting any equipment, one should first make sure that it is adapted to be used with the local voltage in the mains.
 Do not allow children to play with any of the control devices.
 Keep all remote control devices out of the reach of children.
 Observe the opening or shutting of the blinds, shutters, awnings or gates and ensure all persons stand clear until the operation
is completed.
 Control system operators need to undergo preliminary instruction and training and also be made aware of all the potential
dangers that can be encountered. A person should only be authorised to use the control system only once the employer,
administrator or owner is satisfied that that person has been properly instructed.
It is not permitted to dispose of waste equipment together with other waste. Dispose only in specially designated areas.
PERSONAL SAFETY WARNING
1