Proper Care And Cleaning - Whirlpool 8LCH-KKSCSSS5HW User Manual

1. Open door and slide the bottle out.
2. Remove the suction probe from the bottle:
• Pull the suction probe straight up until it's completely out of the bottle.
• Hang the probe on the door to prevent contamination.
3. Install a fresh bottle:
• Place a fresh bottle in the front of the bottle compartment.
• Clean the new bottle with a soft cloth and warm soapy water or a bleach solution,
then wipe it clean with a wet cloth.
• Remove the entire plastic cap from the top of the bottle.
• Insert the probe into the bottle.
• Push down on the suction probe until it is firmly seated.
• Slide the bottle into the bottle compartment.
• Gently close the door.

PROPER CARE AND CLEANING

General Cleaning
Perform: As needed (every 6 months under normal conditions)
Time Required: 5 minutes.
NOTE:
Do NOT use abrasive materials or chemical cleaners.
1. Unplug the power cord from the wall outlet.
2. Clean the cabinet surfaces with a soft cloth and warm soapy water.
3. Wipe dust from back of cooler to improve efficiency.
4. Remove the drip tray assembly by sliding it forward. Remove the cover. Wash the
drip tray and cover with soapy water.
5. Wipe the stainless steel parts of the cabinet with unscented Baby oil (mineral oil).
Sanitizing (Optional for Self Cleaning Systems)
Perform: Sanitizing the interior is not needed in this self clean unit, but it's optional
Time Required: 15 minutes.
NOTE:
Do it prior to loading a fresh bottle.
1. To clean the probe assembly, unplug the power cord from the wall outlet.
2. Move the unit away from the wall and turn it 90 degrees in either direc-
tion.
3. Turn the power switches to OFF.
4. Remove the water bottle and suction probe from the water cooler.
5. Place a 2 gallon or larger bucket under the probe assembly.
6. Remove the air filter and wash it in soapy water.
Air Filter
19