Whirlpool 8LCH-KKSCSSS5HW User Manual page 18

4. Turn the hot and cold water power switches on the back of the water cooler ON.
• The red switch controls the heating of water. If you do not want hot water, leave
this switch OFF. (However it needs to be on to use the coffee brewer)
• The blue switch controls the cooling of water. If you do not want cold water, leave
this switch OFF.
NOTE:
• At initial start-up it will take about 3 minutes for the reservoirs to fill.
• The door must be closed to operate the water pump.
• If the lights continue to flash, your bottle may be empty. If problems persist, Call
1-855-594-4755 toll free for assistance.
Dispensing Cold Water
NOTE:
After setup, the cooler will take up to 1 hour to get water to optimally cold
temperature. During this time the compressor may run continuously. This is normal
during the initial setup.
1. Position your glass, pitcher or cooking pot securely below the cold water tap.
• The right arrow below the cold water control shows the location of the cold water
outlet.
• The target holes in the grill align with the flow of water. This unit dispenses wa-
ter at a fast rate. To avoid splashes, hold the cup as close to the water outlet as
possible.
2. Depress the right control downward to start the water flow.
3. Release the control once the desired fill level is achieved.
Dispensing Hot Water
NOTE:
After initial setup, the water heats up in 15-20 minutes.
1. Place a suitable cup securely below the hot water outlet.
a. The left arrow below the hot water control indicates the location of the hot water tap.
b. The target hole in the grill helps to line up the flow of water. This unit dispenses wa-
ter at a fast rate. To avoid splashes, hold your cup as close to the water outlet as pos-
sible.
2. Push the hot water lock (red) inward and depress the control down to start the flow.
3. Release the control once your cup is filled.
Replacing an Empty Bottle
NOTE:
When your bottle is empty the water cooler will beep intermittently.
You may also hear a sucking sound when the bottle empties. This is normal and is an-
other way to be alerted that your bottle is empty.
Replace the bottle as soon as you note it is empty. If unavailable, leave the door ajar or
unplug the cooler to stop the beeping noise and flashing lights.
There may be a small amount of water left in the bottle. This is normal.
18