Empire Comfort Systems EBL50 Owner's Manual page 10

Fireplace Installation
• Remove the partially reflective
glass from the fireplace.
1. Locate the power cord and
remove the 3 screws that attach
the cord bracket to the unit - one
on the back of the unit and two on
the bottom. (Figure 5)
2. From the front, remove the 2
Philips screws that fasten the front
panel tabs, tilt the panel forward
and lift off. (Figure 4)
3. Unscrew the 3 wire connectors
and separate the wires (Figure 6).
4. Pull the cord bracket and power
cord out the front of the fireplace.
5. Replace removed cord bracket
with the supplied hardwire bracket
replacement (Figure 7) and install
using screws removed in step 2.
6. Leaving a minimum of 3" (7.6 cm)
of slack, route the power supply
through the hole in the hardwire
bracket and secure with a wire
clamp (not supplied).
7. Connect the smooth black wire
(live) from the unit to the black
wire from the power supply
using one of the wire connectors
removed in step 4 (Figure 6).
8. Connect the black ribbed wire
(neutral) and white flicker motor
wire from the unit to the white wire
from the power supply using the
second wire connector from step 4
(Figure 6).
9. Attach green grounding wire to
10
Figure 4
Front Panel tabs (2)
Figure 5
Hardwire
Bracket
Front Panel
Cord
Bracket
Screws
www.empirecomfort.com