Zoom 4311F Quick Start Manual page 8

To disconnect from and unpair a device, see page 9.
Installation and Setup for Macintosh
With Mac OS X 10.3 and later, you do not need to install any
software. The adapter uses the driver embedded in the OS X
operating system. This driver lets you connect wirelessly to
another computer, PDA, modem, or printer.
When this Quick Start was written, the Macintosh driver did
not support A2DP (Advanced Audio Distribution Profile) or
AVRCP (Audio/Video Remote Control Profile). Consequently,
Bluetooth-enabled headphones/headsets were not supported
on the Mac at that time. In the future, Apple may add these
profiles to the OS.
To pair the Adapter with another Bluetooth-enabled device,
follow these instructions.
1 Plug the USB adapter into your computer's USB port.
2 Open System Preferences and click the Bluetooth icon.
3 In the Bluetooth window, on the Devices tab, select Set
Up New Device and follow the prompts.
4 When the Searching for [your device] window appears,
select the desired device from the list and, if the device
requires a specific passkey, select the Passkey Options
button.
In the Passkey Options window, select Use a Specific
Passkey and click OK.
8