Berger & Schroter 31881 Manual page 22

Mounting the wall bracket
Required tools
• Drill
• 6 mm masonry/concrete drill bit
• Phillips head screwdriver
Caution
• Ensure that there are no electric lines, water or heating pipes installed
at the proposed drilling location.
• The supplied wall plugs are only suitable for mounting on
concrete or stone. Before starting the installation, please check your in-
stallation location carefully for its suitability for the plugs. The assembly
material used must be suitable for the respective location. If in doubt,
consult a professional.
Install Steps
• Mark the drill holes by holding the foot of the wall bracket at the de-
sired mounting location and marking the hole positions.
• Use a drill with a 6 mm drill bit to drill the required holes and insert the
plugs and insert the wall plugs flush with the wall.
• Screw the wall bracket to the wall using the supplied screws .
• Mount the camera on the tripod screw and screw the camera a little
way on (about three turns).
• Turn the camera in the desired direction and lock it with the lock nut.
• To move the camera into its final position, undo the two pivot bolts a
little, position the camera and fix the position by tightening the two pivot
bolts .
22