Polk Mono UMC1 Installation And Operation Manual page 10

System Menu
1. Press and hold the Menu button (2) for more than 3 seconds to enter the
system menu. "System Settings" will appear on the display, followed by the
first menu item, "Key Beep".
2. Rotate the Encoder Knob (3) to navigate the system menu and highlight the
desired item.
3. Press the Encoder Knob to select the item and rotate the Encoder Knob to
adjust the selected menu item.
4. Press the Encoder Knob again to enter your selection and return to the
menu list.
5. Press the Swoop Arrow button (7) to return to the previous operation.
6. The following items can be adjusted:
•
Key Beep (On/ Off)
• LCD Backlight (1 – 10), LCD Backlight Night (1 – 10)
• LCD Contrast (1 – 10)
• Button Backlight (1 – 10), Button Backlight Night (1 – 10)
• Power Button Backlight (1 – 10)
•
Tuning Region (USA/ Euro)
•
Bluetooth Setup (Sub Menu, only accessible in Bluetooth mode)
- Bluetooth On/ Off: Turn on and off BT module.
- Bluetooth Device List (Lock/ Unlock, Disconnect/ Connect,
Delete): View, lock and delete from a list of previously paired
mobile devices.
- Bluetooth Pair: Press Encoder Knob to confirm selection and put
the PA4A/UM2 into pairing mode.
•
Low Battery Alarm (On/ Off)
•
Low Battery Auto Off (On/ Off)
•
Zone Toggle (On/ Off): When Zone Toggle is On, Zone Settings and
SUB volume are enabled in Audio Settings, and EQ Settings become
Profile Settings. When Zone Toggle is Off, Zone Settings and SUB
Settings are disabled in Audio Settings.
•
System Reset: Press Encoder Knob once to confirm. (Resets unit to
factory default settings)
•
Firmware: Press the Encoder Knob to view software version
information.
NOTE: BT Pair and BT Device menu options are only available while in the
BT mode.
Battery Alarm Operation
If Low Battery Alarm is set to "ON", an alarm will sound (3 beeps every 30 sec)
when the voltage drops to 10.8V (+/- 0.3V). A visual warning (Battery Low) will
appear flashing on the LCD display.
NOTE: "OFF" is the default setting for Low Battery Alarm. If the audio is
muted or the volume is set to 0, the audible beep will not be heard.
Auxiliary Input
To access an auxiliary device:
1. Connect the portable audio player to the AUX IN cables routed from the rear
of the radio.
2. Press the Mode button (9) to enter mode selection display.
3. Rotate the Encoder Knob (3) to select auxiliary audio input mode, then
press the Encoder Knob to enter auxiliary audio input mode.
Back Key (Swoop Arrow)
In various modes and conditions, the swoop arrow option will be available in the (7)
button. Press the (7) button to exit the current operation without waiting for the
system default time out and returning to the previous menu display.
8
UMC1