Troubleshooting - Dirt Devil INFINITY AC DD5110 Instruction Manual

Multi-cyclonic vacuum cleaner
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13
18
Cleaning the pre-motor filters
CAUTION!
Filters need to be cleaned every time you emp-
ty the dirt container for best cleaning results.
The pre-motor filters can be washed by hand.
Clean the pre-motor filters with water only. The
post-motor filter may not be washed or re-used.
Do not use your vacuum cleaner without all of
the filters in place.
Hold the dirt container and twist the lid an-
1
ti-clockwise (Fig.
15
).
2
pre-motor filter. Lift out the pre-motor filter
(Fig.
).
Check the secondary pre-motor filter
16
3
mesh for dirt. If dirty, lift it out as well (Fig.
excess dirt from the filters or rinse them and leave
to dry for 24 hours. Insert them and close the lid by
turning it clockwise (Fig.
Cleaning the exhaust filter
Post-motor filter is located in the right wheel.
1
Hold the centre of the wheel over and twist wheel
cover anti-clockwise (Fig.
er off the post-motor filter is easily removed. (Fig.
Tap all excess dirt off the filter. It might become
3
necessary to use the 3-in-1 combo nozzle for ad-
vanced cleaning. Do not wash (Fig.
the post-motor filter. Hold the centre of the wheel
cover and twist wheel cover anti-clockwise, until it
clicks into place (Fig.
22
).
Cleaning the mini turbo brush (optional)
Disconnect the mini turbo brush from the han-
1
dle or the telescopic tube.
ring by turning it anti-clockwise (Fig.
fully open up the top of the housing of the mini tur-
bo brush (Fig.
).
Thoroughly clean the brush by
23
4
hand. In case of stubborn soiling, carefully use twee-
zers or scissors.
Place the top of the housing on
5
the 3 tabs on the bottom of the housing and then
carefully close the top of the housing (Fig.
Screw the retaining ring back on by turning it
6
clockwise (Fig.
24
).
Accessory parts and spare parts
• 1 filter set (1 pre-motor filter + 1 post motor filter) –
2620001 (Fig.
25
/A)
• 1 parquet brush – M203-4 (Fig.
• 1 mini turbo brush "Fellino" – M219 (Fig.
• 1 midi turbo brush – M221 (Fig.
• 1 long flexible crevice nozzle – M232 (Fig.
Lift the lid to reveal the
).
17
4
).
18
19
).
With the wheel cov-
2
21
).
Re-insert
4
Unscrew the retaining
2
).
Care-
23
3
).
24
25
/B)
/C)
25
/D)
25
25
/E)
EN

Troubleshooting

Before you contact our Dirt Devil service team or
send the appliance to the Dirt Devil customer service
department, you will find a lot of additional informa-
tion in the service area of our website which will help
you solve problems.
www.dirtdevil.de/service
!
WARNING!
Always switch off the appliance and disconnect
it from the mains socket before starting trouble-
shooting. Never use a faulty appliance.
Tap
).
20

Advertisement

Table of Contents
loading

Table of Contents