Subscribe to Our Youtube Channel
Related Manuals for Baker Hughes Masoneilan Camflex II 35002 Series
Summary of Contents for Baker Hughes Masoneilan Camflex II 35002 Series
- Page 1 Masoneilan* 35002 Series Camflex*II Rotary Control Valve Instruction Manual (Rev.D) BHGE Data Classification : Public...
- Page 2 SPECIFIC REFERENCE INFORMATION IN ADDITION TO THE CUSTOMER/OPERATOR’S NORMAL OPERATION AND MAINTENANCE PROCEDURES. SINCE OPERATION AND MAINTENANCE PHILOSOPHIES VARY, BHGE (BAKER HUGHES, A GE COMPANY AND ITS SUBSIDIARIES AND AFFILIATES) DOES NOT ATTEMPT TO DICTATE SPECIFIC PROCEDURES, BUT TO PROVIDE BASIC LIMITATIONS AND REQUIREMENTS CREATED BY THE TYPE OF EQUIPMENT PROVIDED.
-
Page 3: Table Of Contents
Table Of Contents Safety Information ..................................1 About this Manual ..................................1 Warranty ......................................1 1. Introduction ....................................2 2. General ....................................2 3. Principle Of Operation ................................2 4. Unpacking ....................................3 5. Installation ....................................3 6. Air Supply Piping ..................................4 7. Placing In Service ...................................4 8. Disassembly ....................................4 8.1 Actuator Removal from Body S/A ....................................4 8.2 Actuator Complete Disassembly ....................................5 8.3 Valve Body .............................................5... -
Page 4: Safety Information
Note: Indicates important facts and conditions. © 2018 Baker Hughes, a GE company. All Rights Reserved. 1 | BHGE... -
Page 5: Introduction
7. Perpendicular to pipeline, valve closes on stem extension. 8. Perpendicular to pipeline, valve opens on stem extension. Figure 1 © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 2... -
Page 6: Unpacking
Camflex II valve with a manually operated throttling valve mounted in the by-pass line. © 2018 Baker Hughes, a GE company. All Rights Reserved. 3 | BHGE... -
Page 7: Air Supply Piping
B. Remove rear cover (29) and front cover (32) by removing the two cover screws (30). C. Remove bottom cover (11) and spring barrel boss cover (58). © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 4... -
Page 8: Actuator Complete Disassembly
The spring diaphragm actuator used on the Camflex II valve was designed basically as a low cost non-replaceable item and © 2018 Baker Hughes, a GE company. All Rights Reserved. 5 | BHGE... - Page 9 Remove the shaft and complete removal of the bushing by prying out using the groove provided. © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 6...
-
Page 10: Maintenance
G-1. Apply adhesive tape or cement to the top of the piston. H-1. The inscription “Piston Side” is located on the diaphragm (40). If used, apply cement to this side of the diaphragm. © 2018 Baker Hughes, a GE company. All Rights Reserved. 7 | BHGE... - Page 11 L. Ensure that the diaphragm case (42) is evenly seated on the spring barrel (38), insert the four capscrews (41) and tighten evenly. Figure 7 - Method 2 © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 8...
-
Page 12: Body S/A Internal Parts
D. Slide the valve shaft partly into the lower yoke opening, H. Clean seat ring, plug and valve body thoroughly in pre- allowing enough room to place packing flange (14) over the paration for reassembly. shaft (19). © 2018 Baker Hughes, a GE company. All Rights Reserved. 9 | BHGE... -
Page 13: Handwheel Reassembly
Do not tighten the seat ring retainer to torque specification at this time. LIMIT STOP STD CAMFLEX 4.5" Figure 9 © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 10... -
Page 14: Seat Ring Alignment
K. Install packing (17) insuring that the skive cut of each piece of packing is offset approximately 120° from that of the adjacent piece of packing. © 2018 Baker Hughes, a GE company. All Rights Reserved. 11 | BHGE... -
Page 15: Dvd Plate Reassembly
Figure 13 Note: If the unit is air-to-open, replace clevis locknut (46) and clevis (35). © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 12... - Page 16 N. Replace front cover (32) and rear cover (29) and secure in place with cover screws (30). O. Replace spring barrel boss cover (58) and bottom cover (11) (Snap fit). © 2018 Baker Hughes, a GE company. All Rights Reserved. 13 | BHGE...
-
Page 17: Changing Body Position
6" (DN 150) (228) ⁄ " 8" (DN 200) (228) ⁄ " 10" (DN 250) (228) ⁄ " 12" (DN 300) Figure 14 © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 14... -
Page 18: Manual Actuator Option
P. Proceed to Section 11, on Actuator Stem Adjustment. © 2018 Baker Hughes, a GE company. All Rights Reserved. 15 | BHGE... - Page 19 Previous Design 103 104 100 101 SB Design Figure 16 N°9 Previous Design Figure 17 © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 16...
- Page 20 Applies to previous design only. • Quantity varies according to option. •• Quantity varies according to size and bonnet type. Confirm required quantity from valve serial records. © 2018 Baker Hughes, a GE company. All Rights Reserved. 17 | BHGE...
- Page 21 Figure 19 PACKING FLANGE REVERSED LEVER ARM PACKING STUD NUT STEM PIPE BOLT FLAT WASHER BONNET PIPE Figure 20 Figure 21 © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 18...
- Page 22 1 ⁄ 8 1 ⁄ 8 " : 1 " 8 UNC 2A/2B 1 ⁄ 4 " : 1 1 ⁄ 4 " 8 UNC 2A/2B Figure 22 © 2018 Baker Hughes, a GE company. All Rights Reserved. 19 | BHGE...
- Page 23 " : 1 " 8 UNC 2A/2B D: L16N (18x40x3)mm 1 ⁄ " : 1 1 ⁄ " 8 UNC 2A/2B Figure 23 © 2018 Baker Hughes, a GE company. All Rights Reserved. Masoneilan 35002 Series Camflex II Instruction Manual | 20...
- Page 24 The BHGE logo is a trademark of Baker Hughes, a GE company LLC. GE and the GE monogram are trademarks of the General Electric Company used under trademark license.
Need help?
Do you have a question about the Masoneilan Camflex II 35002 Series and is the answer not in the manual?
Questions and answers