Troubleshooting - Silvercrest SBP 1960 A1 Operating Instructions Manual

Troubleshooting

This section contains important information on troubleshooting. If you are unable to solve the
problem by following the steps below, please contact Customer Service.
Fault Possible causes
The appliance is not
connected to the power
supply.
The appliance is
The device is not
not working.
switched on.
The appliance is
defective.
The appliance The appliance has
interrupts the overheated. This is due
drying process to overloading or
during operation, because the blower
and the timer is blocked.
continues to run.
The set drying time has
expired.
The appliance
simply switches
itself off during
The appliance has fallen
operation.
over.
SBP 1960 A1
Possible solutions
Make sure that the mains plug is connected to
a suitable socket.
Turn the dial clockwise until the desired
drying time is reached.
Contact the Customer Service department.
Turn off the timer. Otherwise, the appliance
will resume the drying process automatically
as soon as it has cooled down sufficiently and
if the set time has not already elapsed.
If necessary, remove the blockage from the
blower . Allow the appliance to cool down
for approx. 5 –10 minutes and set a new
drying time. If the appliance still does not
start, turn off the timer and try again later.
If necessary, set a new drying time.
The appliance switches off automatically if it
falls over during operation. Stand it up and
turn it back on. Always ensure that it is
standing stably.
GB │ IE │
29 ■