AEG Electrolux DD8692-M Instruction Manual page 46

Installation
2 - Direction and position of the ducting fan unit
a) The hood is normally supplied with the air outlet directed towards
the wall (fig. 2), if it is to be installed with the air outlet directed to
the right or left (fig. 3a-b), it will be necessary to change the direction
of the ducting fan unit, proceeding as follows:
• Unscrew the screws U (fig. 12);
• Turn the ducting fan unit 60° to the right or left;
• Replace the screws U.
b) The ducting fan unit air outlets must be arranged according to the
type of installation to be carried out.
• Air outlet directed towards the wall (fig. 2).
• Remove the plastic frame from the air outlet (fig.14).
• Remove the plug from the upper part of the ducting fan unit
(fig.13), as it is not possible to insert the flange F with the plug in
place.
• Fit the flange F Ø120 mm (fig.16), replace the plug.
• Air outlet directed to the right or left hand side (fig. 3a-b).
• Remove the four screws fastening the plastic frame, as
shown in fig. 14.
• Fit the ducting spigot R (fig.17) and replace the four screws
removed as above.
3 - Fixing the chimney
a) Loosen the screws M fixing the two parts of the chimney
and pull the inner
section I (fig.18)
almost all the way
out. Remove the
protective film P.
b) Rest the lower
section of the
chimney in its
housing on the top of
the hood canopy.
Lower the ducting fan unit until it reaches the
wall bracket S and fix it using the screw H
provided (fig.19). Fit the cover D (provided) on
the wall bracket S (fig.20).
46
I
P
M
18
A08_20
15
S
A08_21
12
U
U
A08_14
13
14
16
17
R
S
H
19