AEG Electrolux DD8692-M Instruction Manual page 45

2 - Fitting the fixing elements
a) Insert the rawl plugs provided into holes 1 and 2.
b) Fit the eye bolts O (fig.5).
c) Fix the wall bracket S in hole 2 using the screw V provided
(fig.6).
3 - Fitting the hood canopy C to the wall
a) Remove the metal grease filter (see the paragraph on
Maintenance).
b) Fit the support rod B using the two screws K (3,5x9,5)
provided (fig. 7).
c) Hook the hood canopy C to the eye bolts O fixed in holes 1
(fig. 8).
d) Adjust the support rod B so that it pushes against the wall
(fig. 9).
e) Adjusting position (fig. 10). There are two adjustable hooks
7
B
K
A08_08
at the rear of the
hood, which can be used to adjust its position as follows:
• Turn the screws L until the position of screws N coincides
with the lower access holes.
• Turn the screws N to adjust the vertical and horizontal
position of the hood.
• Lock the screws L to fasten the hood against the wall.
• Insert the plugs T provided in the holes giving access
to screws N.
Installation of the chimney A
No matter which type of installation is being used,
any wooden shelves in the area where the hood is to
be fitted must first be removed, drilled and later
replaced.
1 - Drilling the shelves:
a) Using the cardboard template provided, and
taking hole "B" as a point of reference, drill the
shelves along the central axis to allow the
passage of the chimney. The chimney must be
inserted into the shelves before it is fixed to the
hood canopy C (fig.11).
8
O
O
5
O
6
V
B
L
N
T
L
N
T
A08_11
11
Installation
1
A08_06
S
2
A08_07
O
A08_10
9
L
N
10
45