Tentipi IT Solo pitching kit Quick Manual page 2

IT Solo pitching kit, half inner tent
Attach the top connector to the upper edge of the inner tent using
the O-rings and the five toggles.
There is a floor tensioner at each end of the long side of the inner tent.
Push the toggle at each end through the smaller ring on the ground
tensioner and then attach to the ring on the inner tent.
Attach the fastening strap to the ground using a peg positioned
centrally some way in front of the half inner tent. Put the central pole
inside the sleeve of the top connector and then pitch the inner tent
by pushing the pole upwards. Put it down in the inner tent. Close the
door and tighten all the ground straps. Tighten the long fastening
strap as well so the half inner tent stands straight. Adjust the straps
as required.
Before using the product, please read "Care instructions, hints and advice" at tentipi.com/support
Fasten the O-rings on the three remaining top connector straps (the
ones at the front) to the snap-link on the long fastening strap.
Attach the other three ground tensioners to the lower edge of the
inner tent using the rings and toggles. Use the mounting cross to
position the five pegs in a half-circle. Push the pegs fully down and
pull the five ground tensioners over the pegs.
The IT Solo pitching kit can be used to pitch all models of
Base, Comfort and Pro inner tent, size 5, 7 and 9.
www.tentipi.com