Tentipi Olivin 2 Manual

Pitching your Olivin 2 Nordic tipi

In an emergency, it is possible to make a small open fire in both Olivin cp and Olivin light. A microstove can be used in Olivin cp if the canvas is
protected from contact with the hot chimney. When an inner tent has been mounted, neither a fire nor a stove can be used.
* Packing bag * Central pole
* Canvas * Tent pegs
2. Pull out the measuring tape and put a tent peg by the
marking.
4. Spread the Nordic tipi out and pull the ground rings over
the tent pegs. Push the pegs all the way down. In addition,
read "Peg and stake guide" at tentipi.com/support.
6. Locate the cap at the top of the Nordic tipi and put the
central pole inside it. Raise the Nordic tipi by pushing the
central pole upwards.
Before using the product, please read "Care instructions, hints and advice" at tentipi.com/support
* Mounting cross
* Measuring tape
1. Use a tent peg to pin down the mounting cross where
the centre of the Nordic tipi is to be.
3. Use the mounting cross and the measuring tape to
position six pegs symmetrically in a circle.
5. Assemble the central pole.
7. Place the central pole in the centre of the tent. Close
the door and tighten the ground straps all the way round.
Adjust them till you are satisfied.
www.tentipi.com