Tentipi IT Solo pitching kit Quick Manual

IT Solo pitching kit
For pitching a whole or a half inner tent. The long fastening strap is only needed when
pitching a half inner tent.
Long fastening strap
Attach the top connector to the upper edge of the inner tent using
the O-rings and the eight toggles (five for a half inner tent, see the
next page).
Use the mounting cross to position the pegs. Then attach a ground
tensioner to each peg.
Before using the product, please read "Care instructions, hints and advice" at tentipi.com/support
8 x Ground tensioners
You also need
Measuring tape
Mounting cross
Top connector
Tent pegs
Attach the eight ground tensioners to the lower edge of the inner tent
using the O-rings and the toggles (five for a half inner tent).
Put the central pole inside the sleeve of the top connector and then
pitch the inner tent by pushing the pole upwards. Put it down in the
centre of the inner tent. Close the door and tighten all the ground
straps. Adjust the straps as required.
www.tentipi.com