Canton Smart Amp 5.1 Operating Instructions Manual page 113

• (7) Top Rear left and right [TR]: They reproduce the Dolby Atmos
well. To get an even more detailed spatial impression (3D Sound) you can use
two additional upfiring speakers or ceiling speakers . The upfiring speakers (Dolby
Atmos Enabled speaker) are placed on top of the rear left and right speakers [RER]
®
or the surround speakers [SUR]. When using ceiling speakers the position of the
front speakers [TF] should be left and right in an angle between 30° and 55°, the
rear speakers [TR] in an angle between 125° and 150° above the listening position
(please refer to figure 1.1).
• (8) Subwoofer [SUB]: The subwoofer reproduces the LFE channel (Low Frequency
Effect). Additionally the subwoofer reproduces all frequencies that can not be repro-
duced by "small" speakers und are below the set crossover frequency (e.g. 100Hz)
(please refer to the menu item Crossover [XOV]).
Figure 1.1: Setup Atmos speaker
4
2
Listening position
1
2 Front speaker
3
Rear speaker
4
Front Dolby Atmos up ring speaker
7
5
90°
55° 125°
150°
30°
1
Rear Dolby Atmos up ring speaker
5
Top front left and right
6
7 Top rear left and right
8 Ceiling speakers (with two Dolby Atmos channels)
signals as
®
4
5
3
Figure 1: Home cinema setup
8 3
2
0°
25°
30°
6
90°
1
110°
135°
150°
150°
1
Listening position
7
5
2
Front left and front right
3
Center speaker
4 Surround left and surround right
5 Rear left and rear right
6 Top front left and top front right
Top rear left and top rear right
7
8 Subwoofer
English
2
30°
25°
6
90°
4
110°
135°
7
5
3 1 13