Operation In Man Mode (Manual Mode) - Profoto A10 User Manual

Operation in MAN mode (Manual mode)

With the A10 set to MAN mode, the light output for the groups A, B, C,
and D can be adjusted manually.
• Select group(s) by doing one of the following:
• Press the A, B, C, or D group button [11] to select the
corresponding group.
• To select all groups, press one of the group buttons [11] twice.
When all groups are selected, the A10 will also control the lights
in group E and F (selected on the flash).
26
• When a group is selected, do one or more of the following:
• Use the dial [13] to adjust the light output for the flash power
setting. The adjustment always starts from the current light
output setting (displayed as 0.0 above the group indicator) and
the adjustment value (e.g. +1.2) is momentarily shown above
the group indicator.
• Press button [15] to turn on/off the continuous light in the
selected group.
• Press and hold the group button [11] to turn on/off the flashes
in the selected group.
• The display automatically returns to the main menu after a few
seconds.
Note:
If a light output cannot be set by the flash because it is outside its flash power range, the
A10 beeps to signal that the command was not executed. The flash power of all flashes
in the selected group then remains unchanged.
www.profoto.com