Profoto A10 User Manual page 32

The setting is used to select how the A10 continuous light intensity
should correspond with the flash light output.
There are four setting options:
• MIN: The lamp gets the half intensity, regardless of the selected
energy level (light output).
• MAX: The lamp gets the maximum intensity, regardless of the
selected energy level (light output).
• PROP: The light intensity is automatically adjusted to be
32
proportional to the selected light output (energy level).
• FLICKER FREE: The lamp gets the maximum intensity regardless
of zoom setting.
Ready Signal
Ready signaling is used to indicate when the A10 flash is fully recycled.
There are four ready signaling options:
• BEEP: The unit beeps when it is ready to flash again after
recharging. This option will also enable key sound.
• DIM: The continuous light turns off after flashing and turns on
when the unit is ready to flash again.
• BEEP DIM: The continuous light turns off after flashing. The light
turns on and the unit beeps when it is ready to flash again.
• OFF: No ready signal.
The test button light [12] always comes off after flashing and comes on
again when the A10 flash is fully recycled.
Control Sounds
The setting can be ON or OFF to enable/disable tactile sounds for Dial
and buttons.
Warning Sounds
The WARNING SOUNDS setting can be set to ON or OFF to enable/
disable a warning sound for wrong exposure if a flash is fired before
the Profoto A10 AirTTL has recycled. A warning is also issued if the
www.profoto.com