Table of Contents
Advertisement
Top bar
The top bar displays information about the selected channel, Hi-S,
AUTO/MANUAL, Control mode, Bluetooth and battery status. When
all symbols are active, they will be positioned as below.
AUTO/MANUAL flash control
AUTO/MANUAL is toggled with the AUTO button [8] on camera brand
specific versions of Connect Pro. If AUTO is active, it is indicated with
an AUTO icon in the top bar. If MANUAL is active there is no indication
in the top bar.
When AUTO flash control is active, Connect Pro will adjust the flash
power of all connected flashes automatically for each photo with help
from the Through The Lens (TTL) metering function in the camera.
When MANUAL flash control is active, all flash power adjustments are
done manually from the Connect Pro. The flash power will not change
until you change it.
When toggling from AUTO to MANUAL the flashes will keep the flash
power from the last image shot before switching to MANUAL. So even
if you want to control your lights manually you can benefit from using
the AUTO flash control as a way to reach a baseline from which you can
make manual adjustments.
AUTO/MANUAL selection is remembered when Connect Pro is turned
off and on again.
NOTE
• When AUTO flash control is selected it only impacts groups A-C. Group D-F are
always manual.
• AUTO is not an available setting on the non-TTL version of Connect Pro. On this
version of Connect Pro, the AUTO button [8] is replaced with a Head On/Off button.
www.profoto.com
11
Advertisement
Table of Contents
