Haier HW120-B14876 User Manual page 27

EN
2. Remove the 8 screws (R1 - R8) from lower back
reinforcement. *HW100-B14876
Remove the 4 screws (R1 - R4) from lower back
reinforcement. *HW80-B14876
(Fig. 10-4) and put aside
3. Pull out the 2 iron bars I1 and I2 (Fig. 10-5)
10-6
Note: Keep in safe place
Keep all parts of the transport protection in a safe place for later use. Whenever the ap-
10.4 Moving the appliance
If the machine is to be moved to a distant location, replace the transportation bolts removed
before installation to prevent damage: The assembly takes place in reverse order.
10.5 Aligning the appliance
Adjust all feet (Fig. 10-7) to achieve a complete level
position. This will minimize vibrations and thus noise
during use. It will also reduce wear and tear. We recom-
mend to use a spirit level for adjustment. Floor should
be as stable and flat as possible.
1. Loose the locknut (1) by using a wrench.
2. Adjust the high by turning the foot (2).
3. Tighten lock ut (1) against the housing.
10-Installation
4. Fill the 6 left holes with blanking plugs (Fig. 10-6)
S1
R5-R8
S2
R1-R4
10-5
I1
I2
10-4
10-7
27