Advertisement
Item Description
Models:
1
2
TVM-21
3
4
TVM-27
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Step 1
Use electronic stud finder to locate center of stud.
Note: When mounting to masonry, go directly to Step 2
2
Quantity
Wall Bracket
1
Platform
1
Platform Tilt Platter
1
Nose Piece
1
Wall Bracket Cover
1
Square Washer
1
Flat Washer
1
Platform Trim Piece
1
Medium Hex Wrench
1
Platform Main Bolt
1
Platform Tilt Screws
2
Platform Lock Nut
1
Platform Slide Nuts
2
Support arm
1
Support arm Pivot Bolts
2
Large Hex Wrench
1
Wall Anchors
4
Wall Bracket Bolts
4
Security Strap
1
Small Hex Wrench
1
Step 2
Use wall bracket (1) as template to mark mounting hole locations.
Step 3
Wooden Stud Mounting:
Using 1/8" drill bit, drill mounting holes to a depth of 2".
Using a 10mm wrench, bolt the wall bracket to the wall with the supplied lag
bolts (18).
Note: To make installation easier, dab a bit of liquid soap onto the
threads before driving the bolt into the stud.
Masonry Mounting:
Use a 3/8" masonry drill bit, and drill mounting holes to a
depth of 2".
Insert wall anchors (17) into mounting holes, and tap flush with
hammer.
Using a 10mm wrench, bolt the wall bracket to the wall with the
supplied lag bolts (18).
Step 4
Slide wall bracket cover (5) over support arm, with flat side facing wall.
Insert platform tilt screws (11) up through two countersunk holes in bottom of
Step 5
Insert support arm into wall bracket. Insert support arm pivot
bolts (15) and secure with large hex wrench (16). Do not over
tighten bolts, or arm will not swing freely.
Snap wall bracket cover into place.
3
platform tilt platter (3).
Thread square platform slide nuts (13)
onto platform tilt screws. Loosely secure
nuts using small hex wrench.
Place flat washer (7) in depression in cen-
ter of platform swivel bracket.
Insert platform main bolt (10) through
center of washer.
Place platform assembly on top of plat-
form tilt platter, with main bolt passing
through center hole.
Install square washer (6) onto platform
main bolt, and then thread platform lock
nut (12) onto platform main bolt. Tighten
with medium hex wrench (9). Do not
over-tighten or platform will not swivel.
Advertisement
