OMNI mount TVM PRO Series Installation Instructions

TVM PRO Television Wall Mount

Installation Instructions

Models: TVM 21 PRO
TVM 27 PRO
Parts List:
Item Description
1 Wall Bracket
2 Support Arm
3 Platform
4 Platform Swivel Bracket
5 Nose Piece
6 Square Washer
7 Platform Slide Bar
8 Medium Hex Wrench
9 5/16" x 1" Platform Screw
10 Flat Washer
11 Small Hex Wrench
12 M6 x 20mm Tilt Screws
13 3/8" x ½" Pivot Bolts
14 5/16" Platform Lock Nut
15 Large Hex Wrench
16 Wall Bracket Cover
17 Wall Anchors
18 ¼" x 2" Lag Bolts
19 Security Strap
Step 1
Use electronic stud finder to locate center of stud.
Note: When mounting to masonry, go directly to Step 2
Step 2
Use wall bracket (1) as template to mark mounting hole locations.
Wooden Stud Mounting:
Using 1/8" drill bit, drill mounting holes to a depth of 2".
Using a 10mm wrench, bolt the wall bracket to the wall with the supplied ¼" lag bolts (18).
Note: To make installation easier, dab a bit of liquid soap onto the bolt threads before driving bolt into the stud.
Masonry Mounting:
Use a 3/8" masonry drill bit, and drill mounting holes to a depth of 2".
Insert wall anchors (17) into mounting holes, and tap flush with hammer.
Using a 10mm wrench, bolt the wall bracket to the wall with the supplied ¼" lag bolts (18).
Step 3
3a) Slide wall bracket cover (16) over support arm, with flat side facing wall.
Place flat washer (10) into round depression in center of platform swivel bracket (4).
Insert platform tilt screws (12) up through two countersunk holes in bottom of platform
swivel bracket.
3b) Insert 5/16" platform screw (9) down through center of platform swivel bracket. Place
platform swivel bracket assembly onto top plate at end of support arm, with main bolt
passing through center hole.
Install square washer (6) onto platform main bolt, and then thread platform lock nut (14)
onto platform screw. Tighten platform screw with medium hex wrench (8). Do not over-
tighten or platform will not swivel.
Quantity
1
1
1
1
1
1
1
1
1
1
1
2
2
1
1
1
4
4
1