Error Messages - Ravas -1 Operational Manual

4.3

Error messages

The weighing system has been overloaded. Remove weight.
Signal from the sensor on AD converter is too high. Check sensor
connection.
No signal from the sensor on AD converter. Check sensor connection.
Span calibration data lost. Recalibrate the system.
Calibration point must be higher than previous one and higher than
value of 25. Or enterered value calibration point value is equal to 0000.
symbol is blinking.
The battery voltage level is running low and has to be changed.
(See page 14)
Flashing M, memory is full ( >99.999 kg cannot be shown by using
5 digits), no weights can be accepted to be added. Erase memory.
M
RAVAS-1 7
USER MANUAL –