What To Do If - Zanussi ZWF1000M User Manual

What to do if.....

Certain problems are due to lack of simple
maintenance or oversights, which can be solved
easily without calling out an engineer.
Malfunction
The washing machine does not work
Water leakage
The spin of the clothes is abnormal
There is a peculiar smell in the wa-
shing machine
No water is visible in the drum
There is the remaining water in the
softener's box
The remaining detergent is left on
the clothes
The washing machine does not fill
The washing machine fills and drains
at the same time.
The washing machine does not drain
Vibration of the washing machine
Before contacting your local Service Centre, please
carry out the checks listed below.
Possible Cause / Solution
Close the washing machine's door.
Press the S tart/Pause
Correctly connect the inlet water pipe.
Reload and distribute the laundry evenly in the drum.
Run a washing cycle without any clothes at maximum
temperature using a biological powder.
No fault-water is under the visible area.
No fault the effect of the softener will not be affected.
Empty before next use.
The water-fast component of the non-phosphorus
detergent will be left on the clothes to form into spot.
Please select «Rinse&Spin» programme.
or brush away the fleck after the clothes is dried.
Turn on the water tap.
Check the selection of
Check if the water pressure is sufficient.
Reconnect the water inlet pipe.
Close the washing machine's door.
Check if the inlet water pipe is bent or blocked.
Make sure the end of the drainage pipe is higher
than the water level inside the machine .
Please delete or amend this sentence we would not
recommend for anyone to seal their drainage pipe.
Check if the drainage pumps is blocked.
Check if the drainage pipe is bent or blocked.
Check the height of the drainage nozzle, make
sure it is 0.6-1 meter high from the bottom of the
washing machine.
Level the washing machine.
Fasten the footing.
Check if all the delivery bolts have all been removed.
ZANUSSI
button.
the procedure .
15