Faults - Hawker LIFEPLUS MOD3 Series Owner's Manual

LIFEPLUS MOD3
In case of a fault, one of the corresponding fault codes listed below will appear on the display.
If it is a critical fault, charging will stop and the red fault LED will be illuminated.
Fault
Battery Disconnects
While Charging
Low Battery Voltage
High Battery Voltage
Charger Cell Size
Exceeded
Check Battery
Thermal
Time Limit Before
Gassing Exceeded
Time Limit After
Gassing Exceeded
Owner's Manual

FAULTS

Cause
Occurs when a charging
battery is disconnected
from the charger without
first stopping the charge
cycle.
Occurs when the battery is
first connected and the
voltage is between 1.0 and
1.8 volts/cell.
Occurs when the battery is
first connected and the
voltage is above 2.4
volts/cell.
Occurs when the battery
cell size does not match the
charger nameplate.
Occurs when the battery is
overheating.
Occurs when the charger is
overheating.
Occurs when the overall
charge cycle time limit in
start rate mode is
exceeded.
Occurs when the time limit
after gassing is exceeded.
Press the STOP button before
disconnecting the battery.
Can be reset by connecting a battery to
the charger.
Can be reset if battery voltage is
between 1.8 and 2.4 volts/cell.
Can be reset if battery voltage is
between 1.8 and 2.4 volts/cell.
Check that the number of battery cells
matches the charger nameplate.
Allow the battery to cool.
Battery may need service.
Can be reset by disconnecting the
battery from the charger.
Check that fans are working.
Check ambient temperature (between
32º and 113º F (0º and 45º C).
Inspect to see if charger ventilation is
obstructed or impaired.
Can be reset by disconnecting the
battery from the charger.
Can be reset by disconnecting the
battery from the charger.
27
AM-HLPM3-OM
Rev AB September 2019
Solution