Motorola CT610 User Manual page 8

Setting up your CT610
1. Once connected to the AC power the set-up wizard will then begin. Follow
the prompts to finish set-up. To select OK, press the left soft key below the
display.
Set the time and date
2. Use the keypad to enter the time. The default time format setting is 12
hours, but you can change this to 24 hours under Time format in the Time
& Date menu.
3. Press Next, then enter the date, in the format MM/DD/YYYY.
4. Press Save.
Finish set-up
5. If you want to carry on using the set-up wizard, select Yes. If you don't,
select No and you can start using your phone straight away. You can
change the settings in the menu later.
Turn on Call blocking
6. The set-up wizard will ask you to turn Call blocking on or off. When on, you
can block unwanted calls. For more about this, see page 16.
7. To switch it on, press the left soft key button. To leave it off, select the right
soft key button . You can turn it on later in the main menu.
Note
When Call blocking is switched on, you'll see it on the top right hand of the
display.
You need to have a Caller Display service from your network provider to use
all the features available e.g. Call blocking, Calls List and other Caller Display
enabled features. Charges may apply.
Adding contacts
8. Select Yes to add contacts now (or press the right option button to skip to
the next step).
9. Use the number buttons on the keypad to enter the name of a new contact.
To select the correct letter, press the number button it appears on e.g.
for Emma, press twice and do the same thing to complete the rest of the
name.
10. When you've finished the name you want to save, press Next.
Note
If you make a mistake, go back a digit by selecting Clear.
11. Then use the keypad to enter the telephone number and press Save.
12. To add another, select Yes and then repeat steps 9 to 11.
8
Getting started