Before The First Use - Zanussi ZWF12370W User Manual

Before the first use

WARNING!
Ensure that the electrical and water
connections comply with the installation
instructions.
IMPORTANT!
Remove the polystyrene block and any
material from the drum.
IMPORTANT!
Before the first wash run a cotton cycle at
95°C or 90°C, without any laundry in the
machine, to remove any manufacturing residue
from the drum and tub. Pour 1/2 a measure of
detergent into the dispenser drawer and start
the machine.
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
at the end of the cycle
●
if there is a fault
●
By pressing buttons
simultaneously for about 6 seconds,the
acoustic signal is deactivated (except if there is
a fault). By pressing these 2 buttons again, the
acoustic signal is reactivated.
and
2 3
Child safety lock
This function allows you to leave the appliance
unattended without having the worry that
children might be injured by or cause damage
to the appliance.
This function remains enabled also when the
washing machine is not working.
There are two different ways to set this option:
before pressing the button
●
impossible to start the machine.
after pressing the button
●
impossible to change any other programme
or option.
To enable (or disable) this option press
simultaneously for about 6 seconds the buttons
and until the paddle icon
3 4
(disappears) on (from) the display .
Stand by mode
If your laundry is not removed within 10
minutes after the programme is finished, the
backlight of the display switches off and the
energy saving system will be enabled.
Only the pilot light of the button
to indicate that you must switch the appliance
off.
If you press any button, the appliance will
come out from the energy saving status and
you could set another washing programme or
switch the appliance off.
: it will be
6
: it will be
6
appears
still blinks
6
13