No Wwvb Tower Icon; Set Time Alarm; Activate/Deactivate Time Alarm; Snooze Alarm - La Crosse Technology WT-8005U Faqs

Note: Day of week will automatically set. Press and release the SET Button
once.
 DAYLIGHT SAVING TIME: DST will show with either ON or OF
flashing. Most states use DST, so this should be set to ON. However if the
location does not use DST, use the up or down arrow to turn it OF. Press
and release the SET button once
OTHER SETTINGS:
 TIME ZONE SETTING: From normal display mode, simply press and release the
ZONE/up arrow button to change the Time Zone from Pacific, Mountain, Central
and Eastern. The unit will see the letter P, M, C or E showing above the
seconds.
Note: This clock only has four time zones. Default is Pacific Time Zone.
 FAHRENHEIT OR CELSIUS: From normal display mode, simply press and release
the F/C/down arrow button to change from Fahrenheit to Celsius.
 WWVB SEARCH: When the batteries are inserted or the WWVB Search button Is
pressed, the clock will search for the WWVB signal for 7 minutes. If it does not
find a signal, the tower icon will stop flashing and search again on the hour.
Note: When the clock is searching for WWVB, signal the unit will not be able to
use the other program buttons. The unit can turn off the search by pressing the
WWVB search button one time.

No WWVB Tower Icon

 The digital clock has not received a WWVB time signal in the past 24 hours.
Position the digital clock for better reception.

 Hold the - button to send the Digital clock on a WWVB signal search at night.
 Allow up to 5 nights to receive the time signal.

Set Time Alarm

 HOUR: Press and hold down the ALARM button for 2 seconds until the Hours
flash. Use the up or down arrow buttons to set the Hour. Press ALARM button to
confirm the setting
 MINUTES: The Minute display of the Alarm time starts to flash. Use the up or
down arrow to set the required minute. Press ALARM button to confirm the
setting and to end the setting procedure.

Activate/Deactivate Time Alarm

Press and release the ALARM button to activate or deactivate the alarm.
 With the Alarm time showing, press and release the ALARM button to activate
the alarm.
 The alarm icon (bell) appears when alarm is active.
 The alarm icon will disappear when alarm is inactive.
Note: When the alarm sounds, it will continue for two minutes then shut off.

Snooze Alarm

 When the alarm sounds, press the SNOOZE button to trigger snooze alarm for 5
minutes.
La Crosse Technology, Ltd Page 4