Troubleshooting - pro user PSI600 Operating Manual

Pure sine wave inverter with transfer switch, wired remote control and 30a solar charge controller

Hide thumbs Also See for PSI600:

Operating manual (82 pages)

Table Of Contents

Table of Contents

Available languages

USB port

Connect the USB external appliance to the USB port and switch it on. The USB port on the power inverter

provides a power supply of 5V DC for external USB devices.

The USB port on the power inverter is not designed for transferring data. Do not

connect memory sticks, MP3 player or similar data storage external appliances. Do

not connect any data transfer cable to the USB port.

Remote Port

Connect the remote unit to the remote connection port (L). Before using the remote unit, ensure the

main switch (G) is in "Position II".

WARNING! Do not open or disassemble the Inverter. Attempting to service the unit

yourself may cause the risk of electrical shock or fire. Please follow the safety

instructions when working on the device.

The LCD display indicates in case of an error the appropriate error code:

Error

Description

Code

Battery-overvoltage-protection: The battery voltage exceeds the permissible

range. Check the battery !

Battery-undervoltage-protection: The battery voltage has fallen below the

permissible range. The battery seems to be empty. Check the battery and

recharge when required.

Short-circuit- /over-power-protection: check if the 230V AC load exceeds the

inverters power-limits or is short-circuited.

Overtemperature-protection: The inverter got too hot. Allow 10-15 minutes

for the inverter to cool down, before putting it in operation again. Provide for

good ventilation.

Only at models PSI1000TX & PSI1500TX: PV-reverse-polarity-protection:

Check if PV panels are connected with reversed.

Only at models PSI1000TX & PSI1500TX: PV-overcurrent-protection: The solar

panel seems to deliver too much power and exceeds the maximum PV-input-

power of the inverter. Check your solar panel if it meets the requirements.

Wait 3 minutes before connecting the panels again.

If the device doesn't work at all, an internal fuse might be blown. This happens always for a reason.

Maybe there has been a short circuit, when connecting the inverter in wrong polarity. Don´t try to

replace internal fuses yourself. The inverter has to be checked by the manufacturer or by an

authorized service.