Backlight-Button - pro user PSI600 Operating Manual

Item Description
A
Air-Inlets: Do not cover !
B
MODE-Button: Press the button to toggle the displayed measured values

BACKLIGHT-Button:

- Press this button briefly to turn on the LCD-backlight for 1 minute – press again to
C
turn the LCD-backlight off
- Press and hold this button for 3 seconds to activate the SLEEP-Mode
D
LCD-Display: shows all the relevant information such as voltage, current, wattage, etc.
E
Red LED: Signal-lamp that indicates errors and alarms
F
Green LED: Signal-lamp that indicates readiness for operation
Main-Switch: Switches between the operation modes of the inverter: on/off/remote
only PSI1000TX & PSI1500TX: If AC input is connected to mains supply (J-1), the
internal relay is triggered and socket J-2 is powered by the mains supply, that is
connected to J-1)
Switch-Position 0:
G
Switch-Position I:
Switch-Position II:
H
USB power supply: delivers 1A of current to power or charge 5V USB devices
I
USB power supply: delivers 2A of current to power or charge 5V USB devices
If the requested USB output power exceeds 3A, USB overcurrent protection will be
activated and the USB output will turn off. USB output will resume after 1 sec.
If the battery voltage is lower than 7.5V, USB output is turned off, but will resume
automatically when battery voltage rises over 8,2V again.
only PSI1000TX & PSI1500TX:
J-1: Mains input socket: AC 170V-265V/max.10A; 47Hz-53Hz
When mains power is connected, J-2 will deliver mains power (green LED will blink)
J-2: 230 V socket:
delivers a 230V 50Hz pure sine wave output (Switch-position I and II – only if J-1 is not
connected to mains power or in case of a power outage).
• The output can deliver up to 600W (PSI600) / 1000W (PSI1000TX) / 1500W
J
(PSI1500TX) of continuous power.
• For a short period (max. 20 min) it can deliver an overload power up to 660W
(PSI600) / 1100W (PSI1000TX) / 1650W (PSI1500TX).
• Peak power is up to 1200W (PSI600) / 2000W (PSI1000TX) / 3000W (PSI1500TX)
for max. 1 sec.
If the battery´s voltage is lower than 10.5V, undervoltage-protection is activated
NOTE: Use outputs separately and never connect them to the grid.
Standby-Mode: Inverter-function is OFF (no output on the
230V sockets available, LCD is OFF), 5V-USB-output is ON,
Charge-Function is ON if PV solar panels are connected (the
LCD will light up and charge a connected battery)
Remote-control-function is OFF, Inverter-function is ON
(230V is available on the sockets), 5V-USB-output is ON,
Charge-function is ON if PV solar panels are connected
Remote-control-function is ON, Inverter-function is ON (230V
is available on the sockets), 5V-USB-output is ON, Charge-
function is ON if PV solar panels are connected
7