Troubleshooting - pro user PSI Series Operating Manual

Pure sine wave inverter

Hide thumbs

Table of Contents

Available languages

Setting

Setting- - - - up the inverter

Setting

up the inverter

To set up the inverter, use the appropriate cables to:

connect the positive pole (usually marked with + or coloured in red) of the battery and the

•

positive pole (coloured in red) of the inverter.

connect the negative pole (usually marked with - or coloured in black) of the battery and the

•

negative pole (coloured in black) of the inverter.

Automatic Transfer Switch function (by-pass 1000/1500/2000/3000W only).

•

Connect the 230V AC incoming connection to the input connection using the supplied cable

(not included with 3000W/Hybrid). The by-pass function will automatically take e ect when

a 230V AC external source is connected (UPS mode). When the external source fails, the

inverter function switches on automatically.

Ensure to clamp all cables securely.

The Inverter is now ready to use: Push the main switch to power on the device.

The Inverter is now ready to use:

Please notice the device functions described in chapter "TECHNICAL DESCRIPTION"

NOTE: You can operate the inverter with your vehicle´s engine running or switched o .

However, it is recommended to switch o the inverter while starting the engine.

USB port

Connect the USB external appliance to the USB port and switch it on. The USB port on the

power inverter provides a power supply of 5V DC for external USB devices.

Remote Port

Connect the remote unit to the remote connection port.

Solar panel connection (MC4 connectors). Hybrid PSI series only.

Install your solar panel on the MC4 connectors. The system itself recognizes the connection

and the charging function of the MPPT controller takes e ect.

Battery dipswitches settings. Hybrid PSI series only.

To optimally charge your batteries, the Hybrid inverter is equipped with dip switches. See

chapter dipswitch settings for the correct settings for your battery.

WARNING! Do not open or disassemble the Inverter. Attempting to service the

unit yourself may cause the risk of electrical shock or ﬁre. Please follow the

safety instructions when working on the device.

If the device doesn't work at all, an internal fuse might be blown. This happens always for a

reason. Maybe there has been a short circuit, when connecting the inverter in wrong polarity.

Don´t try to replace internal fuses yourself. The inverter has to be checked by the

manufacturer or by an authorized service.